Main > Main Forum

"Neat" Control Panel idea

<< < (3/3)

patrickl:
Well you could make em yourself but I spent 3 euro (about $4) on 6 12 terminals strips. I guess it wouldn't even be that easy to make em yourself.

A barrier strip would probably be even easier to construct yourself. Basically a strip of wood and some screws. I'd use one screw to tie down 2 spade connectors, but then, for the cost of the spade connectors you should be able to purchase the terminal strips  ...  ::) So you could tie down bare wire, but you better make sure the barriers (between the terminals) are in place  :P

Tailgunner:
Only down side to using terminal strips is it adds 2 (4 if you use terminals) more potential places for a circuit to break.

HaRuMaN:
I used barrier strips as well as spade plugs in my last stand alone controller.  I tell you, it makes life a heck of a lot easier.

Plus, it looks neat.  :)

My controller:
http://www.arcadecontrols.org/yabbse/index.php?board=10;action=display;threadid=17483

Navigation

[0] Message Index

[*] Previous page

Go to full version