Main > Main Forum
Minipac mentionables
Zakk:
--- Quote from: Peale on April 09, 2004, 11:01:16 pm ---So...people who got this might be interested in .250" female quick disconnects?
--- End quote ---
That's it, there's a thread hijacker at work here...I'm reporting you to a moderator!
Oh, wait...heh nevermind ;)
MinerAl:
--- Quote from: Peale on April 09, 2004, 11:01:16 pm ---So...people who got this might be interested in .250" female quick disconnects?
--- End quote ---
Actually the harness comes with .250 (1/4 inch) female quick disconnects on it... but somebody could probably sell little one inch long wires with .187 (3/16 inch) female quick disconnects on one end and .250 male q.d.s on the other.
froggerman:
--- Quote from: Zakk on April 09, 2004, 11:07:03 pm ---
--- Quote from: froggerman on April 09, 2004, 10:34:17 pm ---Micro switches come with either .250" or .187" tabs. Happs tends to use the .187" ones more.
Have you hooked a trackball up to the Mini-Pac? If you have which one are you using? I have the Happs 'Golden Tee' trackball and I had a small problem connecting up it up. If I orient the trackball with the arrow pointing to the back of the machine I can't get it to work correctly. The x-axis is ok but the y-axis is reversed. If I change the plugs around then I have to rotate the trackball 90 degrees but then both the x and y axis opperate correctly. I was wondering if it was just me or if anyone else has noticed something similar.
--- End quote ---
The X axis on the ultimarc trackball was backwards for me (up went down).
--- End quote ---
Yes, that is the same problem that I had. I was going to switch the clock wires on the trackball end. Molex connectors are pretty easy to remove pins. Other than that I haven't had any problems.
Jeehemdee:
--- Quote from: PaulG on April 09, 2004, 04:45:11 pm ---The crimping requirement is actually posted on his website.
--- End quote ---
Would you please give me the link to this...I can't find it
PaulG:
Actually it was a couple months since I read it, and my memory as to what he actually said was off. Under Harness Power he lists this: "All connectors are female 0.25 inch. These are designed for 0.25 inch standard microswitch terminals. They can, by adjustment with pliers, be used on narrower type terminals. All connectors are fully insulated with transparent boots." Guess it wasn't as clear as I remember.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version