Main > Main Forum

centering slot bit for tmolding

<< < (3/3)

zaphod:

--- Quote from: Popcorrin on April 02, 2004, 07:16:58 am ---People that use laminate, do you apply laminate first and then cut your t-molding slot or do you cut your t-molding slot first and try to adjust for the thickness of the t-molding?  I can think of pros and cons of doing it both ways.

--- End quote ---

I cut the slot before laminating.  One less time I need to run the router across the laminate surface.

Navigation

[0] Message Index

[*] Previous page

Go to full version