Main > Main Forum

Cabinet Switch Wiring

<< < (4/5) > >>

Tecil:
Yeah I was going to measure mine and check around to see what else I can find.

Thanks for the info, I think I've got it all figured out now.  I just ordered one of those smartstrips from smartstrip.net

spauldingd:

--- Quote from: Tecil on March 16, 2004, 04:19:33 pm ---Thanks for the info, I think I've got it all figured out now.  I just ordered one of those smartstrips from smartstrip.net

--- End quote ---

I ordered 2 myself.  I figure if I put on in my cabinet I should also have one for my main system.

Chris:

--- Quote from: Tecil on March 16, 2004, 02:05:18 pm ---That smartstrip is exactly what I'm looking for.

http://www.happcontrols.com/electrical_supplies/49000500.htm

That is the switch that is currently installed on the top of my cabinet.

And I assume I would need to replace it with something like this?

http://www.happcontrols.com/electrical_supplies/95084500.htm

--- End quote ---
Yes, or just use a spare arcade button or any momentary pushbutton from Radio Shack.

Tecil:
Actually I'll have some spare buttons when I'm done replacing my control panel's out, so I may just use one of those.

Thanks for the info.

Oldskool:

There's been a few threads on the subject of triggered powerbars.

They're pretty expensive, so I was planning on going another route.

See the attached pic. I'm going to mount a regular light switch on the back of the cab, and put a standard powerbar on the inside.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version