Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Wells Gardner U3000 V-Size won't change  (Read 683 times)

0 Members and 1 Guest are viewing this topic.

Todesengel

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 48
  • Last login:July 30, 2024, 09:42:08 pm
  • I want to build my own arcade controls!
Wells Gardner U3000 V-Size won't change
« on: July 30, 2024, 09:42:09 pm »
I just picked my MAME Cabinet up out of my storage unit, its been sitting in there for 5 years... I turned it on and the v-size is very narrow, and no matter how I adjust the POT, it won't change size. I measured the 100k ohm POT with my DMM and it was fine. I'm not really sure where to look next. Any advice would be much appreciated.
Logged
Pages: [1]
  
Go Up
« previous next »