Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: 2009 Megatouch Ion. Was working, changed battery, now totally dead. Please help.  (Read 1367 times)

0 Members and 1 Guest are viewing this topic.

grewts@rogers.com

  • Trade Count: (0)
  • Jr. Member
  • **
  • Offline Offline
  • Posts: 3
  • Last login:February 10, 2024, 06:49:40 am
  • I want to build my own arcade controls!
I have a 2008 Ion that I just swapped out the hard drive & key to upgrade to a 2009. No problem, worked perfect . Ran for a day on the bench, powered up & down several times no problem. I thought I'd change the battery since it hasn't been changed in forever and i had some new ones, so I did. Go to power on and it's deader than dead??? Nothing, no led lights on motherboard, no fans, certainly no monitor, nothing, just dead. Put the old battery back in, checked all connections, checked power supply. Still dead. I'm at a loss. Wish I never touched it.
My tech skills are limited.
 Any help would be appreciated.
Geoff
« Last Edit: February 08, 2024, 04:32:56 pm by grewts@rogers.com »

grewts@rogers.com

  • Trade Count: (0)
  • Jr. Member
  • **
  • Offline Offline
  • Posts: 3
  • Last login:February 10, 2024, 06:49:40 am
  • I want to build my own arcade controls!
Found the answer to my own problem and thought I'd share. Actually found it on an old post in a forum right here on Forum controls.
There was a similar problem and A poster suggested jumpstarting the motherboard by taking a paper clip or piece of wire. On the 20 pin connector on the motherboard, find the green wire (14th pin and the black one next to it(15th), shove one end in each hole alongside the wires thus shorting them, then power on. I almost fell off my f-ing chair when it worked. I did also have to hook up a keyboard, F1 to cmos and save settings. But it worked. Hope this helps someone. Geoff

mahkeymike

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 769
  • Last login:Yesterday at 04:59:36 pm
lol, i just replied to your PM with basicly the same directions.