Main > Main Forum
Leaf Switch Buttons - Shorter travel?
Oldskool:
I love my leaf switch buttons, but was thinking of making spacers to shorten their travel a bit.
It would be fairly easy to do as they could slip onto the plunger, and would be retained by the e-clip.
Anyone tried this?
Edgedamage:
Just make the gap between the leaf switch smaller.
Oldskool:
--- Quote from: Edgedamage on March 04, 2004, 07:54:08 pm ---Just make the gap between the leaf switch smaller.
--- End quote ---
I'm actually referring to adding spacers to reduce the travel of the button (regardless of switch activation).
If the total travel is 1/4" (I'm guessing), I'd like to decrease it to at least half that .
A 1/8" spacer would do the trick.
Carsten Carlos:
Emberassing - I always think that this is one of the special things I love at my leaf-buttons! :o
Though I have to admit triggering with microswitch-buttons is much easier.
Oldskool:
I added o-rings to my leaf switch buttons, and it has so far been great.
There's less travel, and the rubber cushions the button as well.
Navigation
[0] Message Index
[#] Next page
Go to full version