Main > Main Forum

Building a Star wars yoke from scratch

<< < (19/25) > >>

Generic Eric:
Menace, who long do you think it would take to build the yoke from scratch?

Has anyone built a yoke based on this guide? Geez...I am crazy...the guide was posted for less than a day, and I am asking if anyone has built one yet...

Call me a wanker.

Tiger-Heli:

--- Quote from: froggerman on March 18, 2004, 03:34:59 pm ---Thanks wj2k3. That is the Star Wars yoke overlay. I was looking for the Return of the Jedi yoke overlay that is shown on the yoke earlier in this thread.

--- End quote ---
There's a very high-res one here:

http://www.arcadecollecting.com/caga/unclean/

It was there before Brax posted his, though, I'm pretty sure.

Brax:

--- Quote from: Tiger-Heli on March 18, 2004, 04:24:59 pm ---
--- Quote from: froggerman on March 18, 2004, 03:34:59 pm ---Thanks wj2k3. That is the Star Wars yoke overlay. I was looking for the Return of the Jedi yoke overlay that is shown on the yoke earlier in this thread.

--- End quote ---
There's a very high-res one here:

http://www.arcadecollecting.com/caga/unclean/
--- End quote ---

Hmmm, it didn't seem to upload. But, yes thats where I found it quite some time ago. I was trying to post it to the non-vector category, hoping someone might vectorize it. :)

It was there before Brax posted his, though, I'm pretty sure.


--- Quote ---
--- End quote ---

menace:

--- Quote ---Menace, who long do you think it would take to build the yoke from scratch?
--- End quote ---

hmmm.. hard to say.  I built it over the course of a few weeks with an hour here and there.  there were also pauses so that the construction didn't get ahead of the write-up.  If you have all the parts on hand, i can't imagine it would take that long.

As far as the art goes, I liked the look of the jedi one better just cause it had a bit more color.  Either way it will have to be deformed in photoshop since my yoke isn't the exact same size or shape as the original.

Generic Eric:
Menace

Do you have an estimate on the materials (not including "prototyping cost) to make a yoke based on your design?  I know that you said not any part over $10.  
Good Stuff!

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version