Main > Main Forum

Building a Star wars yoke from scratch

<< < (9/25) > >>

menace:
yep they're slanted--although wider than the original (i am, after all, no longer 12 years old ;D)

as far as rotation goes i'm going to have 60+ degrees in each direction (I had brax do some angle guesstimation for me) and with a 2:1 gear ratio that roughly equals 240-260 degrees or close to 3/4 of a turn--piece of cake--now to just finish building it....

GamingGreg:

--- Quote from: menace on March 08, 2004, 08:05:41 pm ---yep they're slanted--although wider than the original (i am, after all, no longer 12 years old ;D)

as far as rotation goes i'm going to have 60+ degrees in each direction (I had brax do some angle guesstimation for me) and with a 2:1 gear ratio that roughly equals 240-260 degrees or close to 3/4 of a turn--piece of cake--now to just finish building it....

--- End quote ---

So that's about 120+ degrees of turn on the x-axis.  How about the y-axis (the grips)? Is it the same there as well?

menace:
yep going to be the same

could someone tell me if both the x and y return to center?  I'm pretty sure they do but just wanted to double check--its so close to being done now--woohoo.... ;D

Stormy151:
I've seen people mention refurbishing original yokes, is there a place the springs can be purchased?

If not, I'll figure out another way to get them to return to center, I'm basically copying Atari's design.

FractalWalk:
Both X & Y return to center.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version