Main > Main Forum

found a source for multi-color wire... DUH!

<< < (4/4)

nipsmg:
I used all black too..

Here's my problem, however:

I temporarily printed my CPO on a crappy inkjet plotter.. It's very dithered, and while from a distance it still looks great under the plexi, up close it starts to look crappy.  Also, I ran out of funds before getting all of the correctly colored buttons, and eventually have to remove the plexi and CPO to put in the new CPO when I get it.

What I'm worried about is... I'm going to have TONS OF MICROSWITCHES, not connected to buttons, ALL WIRED THE SAME COLOR.  I guess I could turn on the computer and manually click them to find out where they go, but it's going to be a nightmare.. I REALLY wish I had done it differently now.

--NipsMG

eightbit:

--- Quote from: nipsmg on February 24, 2004, 09:06:02 am ---What I'm worried about is... I'm going to have TONS OF MICROSWITCHES, not connected to buttons, ALL WIRED THE SAME COLOR.  I guess I could turn on the computer and manually click them to find out where they go, but it's going to be a nightmare.. I REALLY wish I had done it differently now.
--- End quote ---

This is easy, don't disconnect the wires from the switches. Simply label the switches when you pop them out of the buttons.

Navigation

[0] Message Index

[*] Previous page

Go to full version