Main > Main Forum

Parallel Cable cut away

(1/3) > >>

GGKoul:
Hello

I search the board & internet and I couldn't find the answer to this.

Can someone send me a link that describes what wires are in a parallel cable?  As I planning to create multiple panels and I want to connect the panels via a Male & Female parallel cable.

So each panel will have a Male parallel cable to connect to the Female connection from the IPAC.

Any advise you have will be greatly appreicated!!

Thanks!
-GGKoul

Jake22:
There's no standard for the actual cable itself.  However, the port pinouts are in these places:
http://www.doc.ic.ac.uk/~ih/doc/par/doc/regpins.html
http://www.physics.utah.edu/~ko/WebEshop/E-stuff/pinout_parallel.html

SirPoonga:
There's just 25 pins/wires.  Do with them as you please.

GGKoul:
So the Pins on both the Male & Female cables don't have to match?

IE:  Pin1 Male to Hole1 on Female?

I mean this..  A wire a on connected to the male end is pin 1 and wired to UP... Hole1 on the female is wired to the IPAC as Button1.


So they dont have to match?

GGKoul:
So I'm wondering... Is there a document that says

White Wire is Pin 1
Blue Wire is Pin 2

Navigation

[0] Message Index

[#] Next page

Go to full version