Main > Main Forum

Mounting keyboard encoders....

(1/2) > >>

GroovyTuesdaY:
I have both an IPAC and  a KEYWIZ.  I am wondering what people use to mount them inside their control panels.   Do most people mount them directly to the wood with some screws or do most mount them on some kind of stand off.

If you feel like posting a picture that would be good too. Doesn't need to be big, just something to get an idea from.

thanks,
groovy~ 8)

microwrx:
I know Andy sells PCB feet:


He's also got a pic of a Mini-PAC using them too:


They're pretty common to find in any electronics store.

RandyT:
Ideally, one should use standoffs or nylons spacers (from most hardware stores, usually in the specialty fastener area).  You could also use nylon washers or pieces of hard plastic tubing cut to the proper size.

I've even heard of someone using pieces of a cheap stickpen.  That one gets my vote as the most innovative and inexpensive solution ;)

RandyT

Stingray:
I have a roll of 1/8 rubber -or maybe it's vinyl- sheeting (I honestly can't remember where I got it). When I need to mount a PCB to anything I usually cut a piece of rubber slightly larger than the PCB to mount under it.

-S

Brad Lee:
While I was getting screws at the home depot, I took a look at their 'specialty screws and fasteners' and found some nylon spacers, that were just like a white tube. they were bout 1/2" long, and the same size hole thru it as the screws.

Screw goes thru the hole on the ipac, then the spacer, and then right into the inside of the cab. 1 on each corner and it is VERY secure, nicely standing 1/2" from the inside wood of the cabinet. Did the same in the back with the motherboard

Navigation

[0] Message Index

[#] Next page

Go to full version