Main > Main Forum

Drilling through sheet metal

<< < (2/2)

flampoo:
I have a hard time dropping $35 on a bit I'll rarely use.

SirPeale:
Sell it after you're done.

mp2526:
Right, you can usually get $10-20 bucks for it on eBay, or I'm sure someone around here would buy it off you.

Rocky:
I took my metal CP to a sheet metal shop in town and had them punch the holes for me. It cost less than $35 for one bit  :o


Rocky

paigeoliver:
I agree, buy it, use it for what you need it for, and I will buy it from you for $10 if no one else bids higher.

Or even better, just keep it, as you can NEVER have too many tools!

Navigation

[0] Message Index

[*] Previous page

Go to full version