Arcade Collecting > Pinball

So, who can make me a set of these....

<< < (6/7) > >>

Locke141:
This thread makes me miss having access to the 60 Watt laser.  :(

Mike A:
If it turns out you want to sandwich your artwork, I can get acrylic that is half as thick. It would almost be easier. I had to laser etch the recess for the coin chute. With two pieces I could just cut one coin slot bigger than the other. The coin chute would pass through one sheet, and rest on the other.

pbj:
That's brilliant.  Let's see how the coin chutes do on what you sent me and revisit this. 

 :cheers:

pbj:
Look what arrived last night.



Stuck one in my coin door to check the fit.  Works fine with the chutes.



Here's some goofing around with the artwork...



That red is going to be very hard to get out of a printer, I think.  I'll keep playing with it.

ChadTower:



Might be easier to just print the black and paint the red.

Navigation

[0] Message Index

[#] Next page

[*] Previous page