Main > Main Forum

First build concept feedback - slim/wide/upright/4P cabinet

<< < (3/3)

ChanceKJ:
Yeah, the P1/P2 spots with 7-8 buttons and a trackball can get a little tight on the lower section of that cp design. If I remeber correctly this was the first problem that led me to make my P1/2 button pattern more ergonomic to my hand. Everything seemed to fit like a glove for me after that. Mind you, I did my cp box on the fly after I had the top cut out. No planning, I just marked off what the tolerances for the trackball housing, stick plates, and buttons that would come close to the cp box walls were and built the box. I had my CP top CnC'd through a guy here in Calgary. And then I built the cp box on the fly, they never were drafted. Also, my side panel designs house the 4° tilt of the cp box so I didn't have to build it into the walls of the box itself. 

Navigation

[0] Message Index

[*] Previous page