Main > Main Forum

Slagcoin templates

(1/3) > >>

DietCoke:
Does anyone know which PPI will translate perfectly to the dimensions of a real build?  I'd like to print one to these out for template purposes but can't seem to find the right proportions.

http://www.slagcoin.com/joystick/layout.html

PL1:

--- Quote from: DietCoke on November 15, 2014, 03:51:50 pm ---Does anyone know which PPI will translate perfectly to the dimensions of a real build?  I'd like to print one to these out for template purposes but can't seem to find the right proportions.

http://www.slagcoin.com/joystick/layout.html

--- End quote ---
Have you tried to print it using MS Paint?


--- Quote from: BadMouth on May 18, 2013, 04:34:20 pm ---If it's smaller than a sheet of paper less your margins, ms paint is still capable of printing actual size.
Make sure the dpi is correct and select "Adjust to 100% actual size" under print options.

--- End quote ---


Scott

Slippyblade:
I just printed one out then compared it to a 1-1/8" hole.  Then increased the size of the print, compared again.  Took like 2 tries to get close enough.  Either that or just paste the image into your graphic program and compare it against the in-program rulers and stretch till it is correct.

Generic Eric:
Oh, the memories!
I thought I hit the bullseye with slagcoin until I had to print.   You'll figure it out.   The advice is sound.  You are not alone.

DietCoke:
I'm glad I'm not the only one to have this question!  Thanks to each of you for your tips!

 :applaud:

Navigation

[0] Message Index

[#] Next page

Go to full version