Main > Main Forum

Pac-Pro with longer shaft bottom mounted in 3/4"

<< < (2/2)

jaharr01:
You could take 2 pieces of 3/8 board make the relief area on top of the second board. cut the hole out for the joystick. Then drill a hole in the top board  over where the joystick is cutout then, then glue them together.See side view attached.If your joy sticks are in a line you could cut out the relief with a saw

Jay

AzureKnight:

Thanks for the feedback.

Honestly, I'm not too worried about mounting it or that the shaft would be too long.  I'm worried that the stick won't perform well/correctly with the longer shaft bottom mounted through 3/4" as it was designed to be top mounted with the shorter shaft.

I could top mount it, but I won't be buying one until my CP is done.  It would  be quick and easy to install it bottom mounted.  But since I have a layered plexiglass top on my CP it will be a LOT of work to unhook everything to top mount it.

Navigation

[0] Message Index

[*] Previous page

Go to full version