Main > Main Forum
Grommet for hole in cabinet
mgb:
--- Quote from: chopperthedog on October 19, 2014, 01:11:56 pm ---
A button with the plunger removed and the bottom cut off works great.
good day.
--- End quote ---
The button bezel works great. I used the same method for bass ports on my cab
IAmDotorg:
I used the SwitchCraft USB and HDMI ports (like the one above) on my cab.
If its a continuous cable, one option is to get a metal disk, like 1.5" in diameter or something drill a hole in the middle of it, paint or powdercoat it to match the cab, and put a rubber grommet in it.
I built a car from the ground up and did quite a few plates like that where I needed a wire passthrough that looked good. (In my case, they were polished aluminum.)
Navigation
[0] Message Index
[*] Previous page
Go to full version