Main > Main Forum
3D Printed Atari Yoke Triggers?
RubberB:
--- Quote from: PL1 on September 23, 2014, 01:40:55 pm ---Welcome aboard, RubberB. ;D
Check the part number on the right, outside handle-half -- If it is "040093-01 A" it will work with these non-bushing-style thumb buttons.
Scott
--- End quote ---
Thanks PL1! Glad to be here. The serial number on my handle is that one so my interim plan is to use a black screw with a button head, gluing a nut in place on the screw to act as that ridge on the real part.
PL1:
--- Quote from: RubberB on September 23, 2014, 04:25:39 pm ---my interim plan is to use a black screw with a button head, gluing a nut in place on the screw to act as that ridge on the real part.
--- End quote ---
You may also want to use a little heatshrink/tubing so you don't scrape up the hole in the handle. ;D
Scott
RubberB:
That's a brilliant idea!
paigeoliver:
These buttons get reproduced in aluminum every few years whenever the stock starts getting really low again.
Generic Eric:
--- Quote from: paigeoliver on September 23, 2014, 05:19:58 pm ---These buttons get reproduced in aluminum every few years whenever the stock starts getting really low again.
--- End quote ---
Do you have a source?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version