Main > Main Forum

HELP: Original Asteroids Cab Fix

(1/1)

gargoyle73:
Hey there all, good to be back! 

I am helping a friend get an all original Asteroids cab repaired after a few years of clean running, and could really use suggestions.

ISSUE: marquee lights come on but NO screen action or button lights

I assume try res-seating the pcb?  check power board connections?

In honesty, I'd like suggestions for 'bullet-proofing'/updating cab to get flawless performance?

Thanks so much!

Lee

RandyT:

Marquee lights on original games are usually run straight from the 110v source, so that sounds about par for the course.   It's not playing "blind", so the monitor can probably be removed from the equation.

Check any and all fuses for continuity (power off, of course) and if they are good, see if the power supply is putting out the correct voltages.  It may all check out fine, but it's where I would start with a "dead" machine.

paigeoliver:
You need a multimeter. Without one you can test essentially nothing.

Asteroids can also be a difficult first game to fix up and there isn't a huge price swing between a dead one and a working one, just keep that in mind.

DeLuSioNal29:

--- Quote from: RandyT on July 22, 2014, 05:31:29 pm ---... see if the power supply is putting out the correct voltages.  It may all check out fine, but it's where I would start with a "dead" machine.

--- End quote ---
This, check it with a multimeter.  This video below is very detailed and may help you out.


For an older power supply watch this video:



D

gargoyle73:
Thanks everybody, multimeter in hand and going to check soon, will keep you posted!

Lee

Navigation

[0] Message Index

Go to full version