Software Support > Automated Projects

An other rotating monitor

<< < (4/4)

bandit721:
Cool, thanks! 

I had actually found the shaft/hub on the same site while researching on Google so thanks for the verification.  When I was poking around for the flange bearing I couldn't find anything that had a depth/thickness of less than 1" and my concern is that the shaft on the hub/shaft is only 7/8"...I guess I'll keep looking.

Thanks again for the info!

BorgDog:
Bringing back a slightly old thread, but would this bearing, also from ServoCity work?  https://www.servocity.com/html/1_2__bore_flat_bearing_mount__.html#.VLLvadXF8n5

I'm just getting started on planning my little rotating project and am trying to gather all the parts/spec to get going.

Thanks

RossG42:
I used the same bearings but wish I’d seen that splined hub! Ended up using a splined flange and shaft then marine-Tex epoxy to “set” everything when adjusted properly

Navigation

[0] Message Index

[*] Previous page