| Main > Monitor/Video Forum |
| Cap Kit lists for Mouser (updated 7/10/15) (now with pics!) |
| << < (5/12) > >> |
| ed12:
either as a rule tan's do not :drift: until exposed to heat but i tend to error on the safe side and spec it to dead nut's as it were.. u have to under stand what it dose it >set's the horz freq and lock through a phase lock loop<..so bang on is better ed |
| Sarver Systems:
So it needs to be measured with a ESR meter? |
| ed12:
tan's are 90% always right on. but good measure say' yes when u are buying them.. to remove 1 and test it? it is a 50/50..no need to guess btw the clip u are looking for is called a >s< clip for fuse's what ken is refering to is u can put in a pigtail and or a blade type fuse the board make's it that way,until latter on in the serial # run rickn was the lead eng on the g07/go8 stuff nice guy and is chatty when u ask him q's ed |
| Sarver Systems:
What value should the fuse be? |
| ed12:
let me see if this will make it easier for u btw there is 2 fuses used 1 is the main input fuse the other is the b+ fuse plus u might need a few resistor's, these are 1 ohm job's and act as a fuse AFTER the flyback ed |
| Navigation |
| Message Index |
| Next page |
| Previous page |