Main > Main Forum

Steering Wheel Encoder and U-HID

<< < (3/3)

Paul Olson:
You can configure the optipac for active hi or active lo. Try it at both settings. I can never remember which one the U-HID supports, but the optipac can use both. I have an optipac because I have 4 devices not supported on the U-HID.

AndyWarne:

--- Quote from: Paul Olson on May 19, 2014, 12:21:53 pm ---You can configure the optipac for active hi or active lo. Try it at both settings. I can never remember which one the U-HID supports, but the optipac can use both. I have an optipac because I have 4 devices not supported on the U-HID.

--- End quote ---

The inputs on the U-HID are pulled up so the input device needs to actively pull low or float, as almost all do.

lamprey:
I've been sick the last few days so I haven't had a check to check things out. I had some time tonight, so I played around some more. It appears that all the PCB's are working now. I was able to get the mouse moving using the Opti-pac set to Active High. Unfortunately, I can't seem to get the U-HID working with these PCBs.

At any rate, the assistance is much appreciated! I'm glad to have things actually functioning.

 :cheers:

Navigation

[0] Message Index

[*] Previous page

Go to full version