Main > Main Forum

Missile Command trackball mounting plate

(1/2) > >>

Paul Olson:
I just had a few of these made. Is this something anyone else can use? I just sent my drawing to the local waterjet place, and they cut them out. They are pretty cheap to have done, but there was a $50 minimum, so they made 4 for that price. I will probably end up selling the 3 extras at some point, but if anyone needs one and can get them cut locally, I can send you the dwg file. I just used round holes for the mounting bolts because square holes are expensive to cut on a waterjet.


Edit: I got a request for the drawing, and it is pretty small, so I am attaching it to this post.

Paul Olson:
I attached the drawing so feel free to use it if you need one of these. The waterjet place I used will do multiple drawings at one time to help get to the $50 minimum. I didn't need anything else at the moment, which is why I ended up with 3 extra of these instead of something I can use.

mnewt:
Thanks for sharing this

Generic Eric:
I have several 4 inch trackballs.  How much would you charge to 58220?

Paul Olson:

--- Quote from: Generic Eric on May 08, 2014, 01:08:57 pm ---I have several 4 inch trackballs.  How much would you charge to 58220?

--- End quote ---

I could send you my 3 extras for what they cost me plus shipping (Looks like it is about $12.50 for a medium flat rate box), so $50. If you have a waterjet place there, you can probably get 4 made for the same price with the drawing. Either way works for me. I can send you these ones if you don't want to mess with it.

Navigation

[0] Message Index

[#] Next page

Go to full version