Main > Main Forum
Attaching acrylic to CP
shponglefan:
Buttons will hold it in place and T-Molding around the edge will help prevent edges from being lifted up.
s_busby_uk:
By curling are you referring to the artwork?
Ken Layton:
--- Quote from: s_busby_uk on May 07, 2014, 12:06:08 pm ---By curling are you referring to the artwork?
--- End quote ---
The artwork AND the Lexan. After a while the Lexan can bow upwards.
Ken Layton:
--- Quote from: keilmillerjr on May 07, 2014, 11:20:07 am ---
--- Quote from: Ken Layton on May 07, 2014, 11:17:38 am ---On a game that is going out on the route, we use "carriage bolts" to hold the Lexan in place and keep the edges from curling up.
In a home use, you could probably use ordinary nuts-and-bolts.
--- End quote ---
What tool or punch do you use to make the square holes?
--- End quote ---
I use a small square file.
s_busby_uk:
--- Quote from: Ken Layton on May 07, 2014, 02:53:50 pm ---
--- Quote from: s_busby_uk on May 07, 2014, 12:06:08 pm ---By curling are you referring to the artwork?
--- End quote ---
The artwork AND the Lexan. After a while the Lexan can bow upwards.
--- End quote ---
Hmm, that does sound problematic. Do you think from my attached CP that I need worry too much? Wouldn't the curved surface make it a bit tricky to pin it down the most effectively?
(Ignore the weird marks, there were some annotations I haphazardly removed in Photoshop)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version