Arcade Collecting > Merit/JVL Touchscreen

Trying to power up a Megatouch motherboard

<< < (7/17) > >>

ed12:
he's right in the stack

first make sure all your dip switch's are off and try it again..
if it fail's turn on 3&7 or 4&8 this should allow the game to rebuild it's self from the back-up
.dat file

ed

gio_aus:
how likely is it a hard drive error? this is a brand new ssd not an old IDE drive. I played around with the dip switches but didn't really do anything. At one stage i got

LILO 21.6 Loading Linux...............
Uncompressing Linux... Ok, booting the kernal.
INIT: version 2.78 booting

but it was stuck on that screen. after that i couldn't get past Ok, booting the kernal.

ed12:
ssd in a megatouch ????
thats new.
maybe makeymike can chime in?
they are kernel driven  >ide and or sata<
soild state drive ???
it is looking for it's boot sector....which >ssd< dose not carry with it..
ie the mfg #

ed

gio_aus:
Its one of these, plugs directly into the IDE port and uses the 4 pin power. Made by King Spec

mahkeymike:
Doesnt look like an official merit hard drive. Looks like a cheap IDE flash drive. I was under the impression that you could not install onto non official hard drives with any software pre 2005 maxx/force. I dont have a maxx mobo to test this though. Only have XL/Force/ION mobo's.

Navigation

[0] Message Index

[#] Next page

[*] Previous page