Main > Main Forum
Using PCBs to wire a control panel
keilmillerjr:
I would not be a happy camper if I bought a cab like this and wanted to replace a control. Looks cool. Practicality seems foolish.
If you wanted to make use the pcb idea, make the button pins slide into a female socket on the pcb. Just my opinion. Regardless, you sir have some skill.
Slippyblade:
--- Quote from: keilmillerjr on April 29, 2014, 05:19:46 pm ---I would not be a happy camper if I bought a cab like this and wanted to replace a control. Looks cool. Practicality seems foolish.
--- End quote ---
The mass majority of folks don't repair things. Look around at nearly any consumer product any more, they are disposable. Engineered to be cheap to manufacture and nearly impossible to repair. These are the people who were the target market for things like...
surface tension:
It's a few months since I created this thread, but after reading the comments I went on the hunt for some PCB-mount crimps to make the changing over of switches a lot easier. I finally found some and after a test run, we're now shipping this way.
The backs of the individual buttons can be popped down, then the PCB levered off.
TopJimmyCooks:
Very nice implementation. Can I ask what general volume of coffee tables you are selling?
surface tension:
Thanks! We don't sell huge amounts, but enough to keep a few people very busy.
Navigation
[0] Message Index
[*] Previous page
Go to full version