Main > Main Forum

Aimtrak guns - software utility won't run.. - SOLVED -

<< < (2/3) > >>

radiofrog:

--- Quote from: chopperthedog on April 26, 2014, 08:16:35 am ---I found that the utility applies changes to the gun itself and used another computer to config gun. Long press of the trigger (10~12 sec default) will get you to calibrate mode on any computer.
--- End quote ---

Interesting. Unfortunately, I don't have an easy way to hook up another computer to that monitor, since it's in my arcade cabinet. And my laptop is a Moc with no VGA hookup.

However, if I were to set up the red dot mode, and make any other setting changes in the utility on another computer, would those then all hold in the gun? If so, I could conceivably do a back-and-forth between two computers to set things up.

AndyWarne:

--- Quote from: radiofrog on April 25, 2014, 10:21:15 pm ---Thanks, I did already try that, though. Same result.
BTW, it's in Win7, 64.

--- End quote ---

Are you sure you didnt hear back as I replied about this very issue a few days ago to someone.

My reply was:

Try locating the Composite Device which is located under the USB Controller entry in Device Manager. Right click and "uninstall" this. Then unplug and reconnect the gun.

radiofrog:

--- Quote from: AndyWarne on April 26, 2014, 05:07:39 pm ---Are you sure you didnt hear back as I replied about this very issue a few days ago to someone.
--- End quote ---

Yes, I'm certain; I was even checking my junk mail box. Anyway, thanks so much for responding here, Andy. Right now, the gun and sensor are unplugged. Does the order in which I proceed from here matter, as far as whether I try to run the utility with either device plugged in or not?

Also, I see 2 USB Composite Devices in Device Manager. Would one of those be for my XArcade stick (w/ trackball)? Would it be wise to ham-handedly uninstall both?

Malenko:

--- Quote from: radiofrog on April 27, 2014, 12:08:48 pm ---Also, I see 2 USB Composite Devices in Device Manager. Would one of those be for my XArcade stick (w/ trackball)? Would it be wise to ham-handedly uninstall both?

--- End quote ---

just unplug the xarcade first

radiofrog:
Dang, I just don't get what's wrong here.  I had all devices unplugged and was left with 1 Composite Device.  I uninstalled that, then plugged in the sensor and 1 gun.  Now Device Manager shows 2 Devices again.  Should I be ignoring the sensor for now?  Going to tinker some more...

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version