Main > Main Forum
Ultimarc trackball with Golden Tee Complete
(1/1)
wirenut:
Maybe this is a question for Andy over at Ultimarc but here goes...
I am about to start a new cabinet build and plan to put in Mame and a Golden Tee Complete PCB that I just picked up. I looked at the manual for the Golden Tee and the trackball plugs straight into the PCB. (Not through Jamma)
I have a 3" Ultimarc trackball. Will this work with the Golden Tee Complete without any kind of interface?
AndyWarne:
I would think it would almost certainly work.
The outputs from our unit are standard quadrature, as on other units.
wirenut:
Thanks for the response Andy and congrats on your new Ultimate interface! I will be picking one up for the next project for sure.
So I am still a little confused on how to hook the trackball up to the Golden Tee's dedicated trackball connection.
I have attached a picture of the pinout that I found for the 6 pin connection on the Golden Tee board and also the U-Track Pinout. Can someone please help me make since of this? If I hook it up color for color will it work? :dizzy:
PL1:
--- Quote from: wirenut on April 20, 2014, 09:27:43 am ---If I hook it up color for color will it work?
--- End quote ---
Yes.
Red is 5v and black is ground.
If an axis is moving the opposite direction you expected, switch the data pair (yellow/green or blue/purple) for that axis.
Scott
wirenut:
Thanks a lot! I'll be starting a build thread in the project section next week.
Navigation
[0] Message Index
Go to full version