Main > Main Forum

mounting the pc

<< < (3/3)

keilmillerjr:

--- Quote from: DarakuTenshi on February 27, 2014, 08:30:44 am ---
--- Quote from: eds1275 on February 27, 2014, 07:05:45 am ---VELCRO! I'm not even joking.

--- End quote ---
On my first build I used industrial strength Velcro to hold my control panel in place. That stuff is amazing.

--- End quote ---

I use that stuff to hold hid ballasts (flat on ram air covers) and igniters (vertical on my custom speedo bracket) on my street bike. Both held incredibly well. Crashed a few times without them budging. However, you have to be real careful when separating that you don't take both Velcro strips with each other.

Industrial Velcro is now holding my apex boost controller to the custom no-radio gauge panel on my rx7. Good stuff.

edekoning:

--- Quote from: NickG on February 27, 2014, 08:24:58 am ---It cannot fall over it if is already on its longest dimensions......for shifting? - velcro.

--- End quote ---
Sure it can, if you put the cab on its side for maintenance/moving/etc.

dcninja:
I was thinking that for whenever i eventually get a house... the moving... but i guess at that point i cna just remove the pc and reinstall it. lol no big deal right

Nephasth:
We're talking a few screws here man.... :dunno

Navigation

[0] Message Index

[*] Previous page

Go to full version