Main > Main Forum

Atari yoke questions

<< < (4/4)

jdbailey1206:

--- Quote from: PL1 on February 23, 2014, 11:26:39 am ---If you're spending that much for a 320 degree pot, why not get this one from ArcadeFixIt?

No filing required.   :cheers:


Scott

--- End quote ---

+1 for Arcadefixit.

cj138:
Hey guys, thanks for all the advice.  I picked up a new pot from arcadefixit and installed it.  I also built a mount and wired the triggers and pots to my APAC.  For some reason the cursor keeps jumping around and I cannot calibrate the yoke.  Very frustrating.  I am very new to this and apologize in advance if I am making stupid mistakes.  I daisy chained the grounds from the triggers and the pots together, I also left two connectors disconnected so I can add buttons once the panel is closer to complete.  Might this explain the unsteady calibration?  I will draw a wiring diagram or take pictures if it will help.   :banghead:
Thanks much,
Cj

cj138:
Good Lord, I am sorry folks. My soldering skills are a joke. I reexamined and saw a loose wire. Nothing to see here. Please move along.

Navigation

[0] Message Index

[*] Previous page

Go to full version