Main > Forum/Website Discussion

1/2" tmolding question regarding slot cutter

(1/1)

kz1911:
Anyone here ever use 1/2" tmolding on a cab? if so what size slot cutter did you use? i have a 1/16 thickness cutter that i used for the 3/4 molding but it has a thicker material than the 1/2"
any advice is appreciated

DaOld Man:
The t-molding.com site says 1/2" T-molding uses a 1/16" slot.

I have used 1/2" t-molding on A Little Rage. I used 1/2" thick MDF and the t-molding fit it just fine.

kz1911:

--- Quote from: DaOld Man on February 10, 2014, 07:59:57 pm ---The t-molding.com site says 1/2" T-molding uses a 1/16" slot.

I have used 1/2" t-molding on A Little Rage. I used 1/2" thick MDF and the t-molding fit it just fine.

--- End quote ---

ok, i think it might work, the 1/16" just seems little too large for the 1/2" that's all, I think my cutter runs wobbly and makes the slot larger than it should that's why, might have to get another one

DaOld Man:
Cut a slot in a scrap piece of wood, cut off a short piece of your t-molding and test fit it in the scrap wood. Make sure it fits before you cut the slot in the cabinet. Better safe than sorry.

Navigation

[0] Message Index