Main > Main Forum
Atari Yolk 14 tooth gear Repoductions
lilshawn:
alright, let's contact an injection moulding company and just mould our own.
couldn't cost more than a couple thousand bucks to set up. then each one is peanuts right?
how many you want? 20000? gotta make enough to make it cheap.
/sarcasm
RandyT:
Google doesn't seem to have a guano translation filter, so I'll just forge ahead. Here's the new design in white ABS;
These are pretty much straight from the machine. I had to change the design a bit, in order to accommodate a raft-less print. So I must concede one point to Steve; I won't be able to offer them for $5 each. Due to the changes, I will need to charge $6 each.
"Glue-Gun" indeed :lol
SammyWI:
Those look pretty nice. Sorry if I missed this earlier but how will these be secured to the shaft without a collar and set screw (grub screw)? Also what layer height are you using?
lilshawn:
it appears these will press onto the original collar. He did some preliminary testing with pressing them on to the original collar and he basically had to break them to get them back off again. Shouldn't be an issue at all with them falling off or anything.
Slippyblade:
I'd give a toe off my left foot for one of those "glorified glue guns". My brother-in-law works in a R&D fab and he routinely prints replacement plastic parts for his project car. SOO jealous.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version