Main > Main Forum

ipac config issue

(1/1)

Toadie:
Well I'm pushing forward on my CP and I have a unique issue that I haven't seen before…

Coin1 seems to be tied to 2B but in the software only ???  Anyone every seen something like this before?

If I unplug one or the other both buttons will light up in the ipac software.  If I reassign them then it doesn't appear to happen.  I'm utterly confused right now.

Richardgregory:
Have you tried flashing back to default values?

Hoopz:
Check your grounds?  Not sure that would do it, but I'd definitely rule it out as an issue.

Toadie:
I think I got it, I think I accidentally programmed the board when the settings weren't up to date and then forgot to reprogram it.

Navigation

[0] Message Index

Go to full version