Main > Main Forum

Pressure Waves in my control panel art

<< < (3/3)

PL1:
Trim the art so it is just slightly (~1/32" - 1/16") smaller than the panel/plexi.

Sharpie/black paint around the panel top/edge so that the part not covered by the art blends with the t-molding.


Scott

jdbailey1206:

--- Quote from: spratkobasa on November 22, 2013, 10:19:46 am ---I didn't want to have a vinyl or glue so that if anything happened I could removed the artwork to do repair on joysticks etc.  If I glue it I wouldn't be able to get my joysticks out of my control panel as it is top mounted.

--- End quote ---

Completely understandable.  Most joysticks can be removed from their housing without removing them from the control panel. 

spratkobasa:
Thanks everyone for your help.  I took my scalpel and did several more passes to get rid of any excess paper going over the edge.  I double clamped the area I was hammering in.  Then declamped and reclamped all the way as I progressed along the edge of the control panel.  Zero pressure waves :).

Navigation

[0] Message Index

[*] Previous page

Go to full version