Main > Main Forum

ultrastik 360's not working

<< < (2/3) > >>

trendy21:
thanks ill try my laptop again when i get home, the motherboard i have running is a biostar mcp6p m2+ if someone could tell me anything about the usb ports on that, also my led lights to the stiks stay on the whole time, ill see what i can find on the board too

trendy21:
i should also mention i dont have the tower just the board mounted inside my cabinet so i think the usb are plugged directly to the board

trendy21:
okay so last night i plugged them into my HP dv7 laptop on the right side assuming those were 2.0 hubs and same thing occured no communication code 10 cant start then i plugged them into the left side 3.0 high speed i thing and they came up in game controllers finally as a hid compliant controller, so im talking with andy from ultimarc to upgrade the firmware from my laptop, or sending them to him and he will test and upgrade them, as far as how to make my ports 3.0 or high speed or dedicated, what can i buy to make that happen it says they are powered hubs and each stick is 100mA of 500 and voltage was 4.94 i saw in the bios i think, i know they make a booster or something along those lines if someone knows a good brand to look at, thanks

drventure:

--- Quote from: trendy21 on November 15, 2013, 09:27:33 am --- as far as how to make my ports 3.0 or high speed or dedicated, what can i buy to make that happen

--- End quote ---

You'd have to buy a daughter board with USB30 ports on it if the MOBO doesn't already have USB3.

Something like this

http://www.newegg.com/Product/Product.aspx?Item=N82E16815287015

trendy21:
thanks i will let u know how that and sticks turn out

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version