Main > Main Forum
Haloween Arcade Post! Custom controller!
pbj:
Well, I've been reusing the same set of cheapies because it got left behind in a rental and my mother in law insisted I take it home while I was helping her clean it out. After you fly something 3,000 miles you feel compelled to use it. After three years of service, they fell apart halfway through the carving.
The hacksaw blade works so well I'm kind of ashamed I didn't think of it sooner. Matt's idea looks like something you could occasionally use for something else, too.
:cheers:
Vigo:
Pretty much had the same project this year for cutting blade. Used a pex pipe crimp to hold the jigsaw blade in the slit I made in the dowel.
BadMouth:
I used a dremel with a spiral cutting bit last time I carved a pumpkin.
It works awesome, just don't let it get away from you.
It was a skeleton hand with it's middle finger extended. It was directed at the the guy across the street. :lol
I did turn it around and put the side with the finger against the house on trick or treating night.
I'll see if I can find the pic. It looked awesome.
lcmgadgets:
A Dremel! Oh, I am so doing that next year!
matt4949:
--- Quote from: lcmgadgets on November 01, 2013, 10:31:25 am ---A Dremel! Oh, I am so doing that next year!
--- End quote ---
Why wait? You can get pumpkins dirt cheap right now.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version