Main > Main Forum

Pin out for Tornado PCB for Opti-Pac

<< < (2/2)

fatsgt:

--- Quote from: BobA on October 27, 2013, 10:50:16 pm ---So provide a pic of the underside of the PC board so that we can see what the actual circuit is.

--- End quote ---

Here ya go.   Now I'm also concerned that there is no chips on this board.

fatsgt:
Sorry, double post

fatsgt:

--- Quote from: tron84 on October 28, 2013, 11:30:51 am ---Was there a reason for replacing the Tron spinner?  If the optic board finally went in it, you could have got a reproduction optical board for the Tron spinner.

--- End quote ---

You know, there really wasn't anything wrong with my Tron Spinner other than it being large and bulky. It has served me well for over 10 years with almost no thought.

I was upgrading controls (Fancy LED's) and I had to remove the knob and Rod from the spinner.  A bit of a pain but afterwards I was having issues getting it put back together. Couldn't get the knob rob to go back in correctly, even after I tightened down the small screws with the allen wrench  the rod was just turning without moving the optic wheel.  I said screw it, I'll try one of these fancy new spinner and see what all the fuss is about. 

So far not my favorite purchase.

fatsgt:
Found the answer in this post. http://forum.arcadecontrols.com/index.php?topic=52175.0

Thanks anyway.

Navigation

[0] Message Index

[*] Previous page

Go to full version