Main > Main Forum
Nintendo Control Panel Measurements
jdbailey1206:
I hate (ass outta you and me)ing Rick. From what I can gather from the plans A (on drawing two) is 1/2" deep by 1/2" high running the length of 22.5 inches of the cab. If we were to go with that then B would be 3.35 inches and C would have to be an inch. A on the original drawing can assumed to be 7.875 but thats only until it meets the bottom bezel retainer. If thats the case and our notch is only .5 inches deep then the entire board would be 8.375 inches.
I just hate to assume when someone on here can do me a kindness and pull out their CP and measure it. :cheers:
Navigation
[0] Message Index
[*] Previous page
Go to full version