Main > Main Forum

Drilling plexiglass

<< < (4/4)

spystyle:
I never had trouble drilling plexi, I use normal drill bits (not pointed) as they are somewhat round on the tip, and I set my drill to run backwards. I drill through at high speed and it kinda melts through.

Craig

ahofle:
If using a regular drill (i.e. not router), I found that high speed + low pressure (so it melts like spystyle said) works the best.  Pressing down too hard causes the cracking.

Navigation

[0] Message Index

[*] Previous page

Go to full version