Main > Main Forum

Marquee light and Power switch wiring

(1/3) > >>

thehammer12:
Im building my first arcade from scratch and Im trying to salvage what ever parts I can from this cabinet that I got a sweet deal on, as you can see in the pic (a little bit) the marquee light is tied into the power switch with a connecter and then the power switch has its owner connector at the bottom which Im guessing goes to a board or some other connector.....etc.

If I want to save this do I strip or take off he wires from the power switch and just tie it into the jamma connector/power supply directly? Also, do I do the same as well to the marquee light?

Im trying to go off the jamma wiring diagram but it doesnt say anything about using or not using connectors

 :dizzy:

BobA:
Your marquee light looks like a standard 120V flourescent with starter.  It connects to AC not the jamma harness.

thehammer12:

--- Quote from: BobA on October 07, 2013, 11:22:33 pm ---Your marquee light looks like a standard 120V flourescent with starter.  It connects to AC not the jamma harness.

--- End quote ---



So I should leave it tied into the power (switch)? Its tied in to the wires via connector about 7-8 inches down from the switch which is not visible in the photo but it is connected.

BobA:
Yes a standard florescent light gets its power from the main power in the cab.

thehammer12:
Ok thanks, If you also dont mind Im gonna post a pic of it and maybe you can tell me if it looks right.

Navigation

[0] Message Index

[#] Next page

Go to full version