Main > Main Forum

Spinner

<< < (2/2)

yotsuya:

--- Quote from: Richardgregory on September 30, 2013, 12:24:47 pm ---Thanks for all the information on the knobs - question though:  if I order the TT2, they automatically give you the stock knob and they don't replace it if I order a different knob do they?

--- End quote ---

I upgraded the knob on mine when I ordered and only received that one. The stock knob was not included.

Richardgregory:
Thanks - oh.....so they take the stock knob out.  Hmm.....was hoping they'd leave it in - never hurts to have a spare and besides one my prefer the lower stock version over the other.

PL1:
The only reason I have both is that Randy allowed me to buy the rubber knob and steering wheel as part of a later order.    :cheers:


Scott

GeoMan:

--- Quote from: Richardgregory on September 30, 2013, 12:24:47 pm ---Ooops, my mistake - I didn't see that picture of the Ultimarc with the PCB interface attached - hmm, it is smaller than the TT2's too, so that's kind of nice.

--- End quote ---

You don't need the PCB interface if you use a MiniPac to drive your control panel. You can connect the spinner directly to it.

Here's the diagram: http://ultimarc.com/mp_inst.html

Navigation

[0] Message Index

[*] Previous page

Go to full version