Main > Main Forum
Probably a very easy NOOB question here about 4 way joystick
(1/1)
braidsrx:
Hello experts!! I recently bought a wiring kit and joystick from ultimarc.com. I chose a stick that could be restricted to true 4 way use because I am using it to rebuild a CP for Q*bert. My question is, the stick has a moveable restrictor plate that can be tightened with screws... but I'm unsure which position locks the corners out ( leaving only up, dn, L, R able to hit switches). Can anyone advise? Sorry if this is covered elsewhere. And any advice on getting the angles perfect to mount the stick correctly ? ( a 45 degree turn to allow for authentic Q*bert moves... :) Thank you all in advance !!!
Vigo:
If it is the type of restrictor plate I am thinking, the plate will a have diamond shaped hole when restricting to 4 ways.
dgame:
You want the restrictor to be in a diamond shape where each direction is a point on the diamond.
jimmer:
You want the restrictor plate rotated to diamond shape relative to the square/rectangle joystick base. Then you want the joystick at 45degress in your panel.
EMDB:
--- Quote from: jimmer on September 18, 2013, 05:06:29 am ---
You want the restrictor plate rotated to diamond shape relative to the square/rectangle joystick base. Then you want the joystick at 45degress in your panel.
--- End quote ---
Or use their UltraStick360 which you can configure in software to have 4-way diagonal directions for Q-bert (and 2/4/8 way for all other games as a bonus).
Navigation
[0] Message Index
Go to full version