Main > Main Forum
Control panel material
Richardgregory:
I'm planning on making a new control panel. Should I use 3/4" plywood or MDF? Which material is easier to work with - is one more of the harder wood?
Nephasth:
Stainless steel.
severdhed:
i always used particle board for my panels, until the last one i made i used MDF...and i loved it...it is so smooth and easy to cut, i highly recommend MDF
mgb:
MDF will be the easiest to work with and the cheapest.
PL1:
MDF is good stuff as long as you:
1. Make sure to use proper eye and breathing protection.
2. Remember that the dust gets *EVERYWHERE* -- work it outdoors with the garage door closed, if possible.
Scott
Navigation
[0] Message Index
[#] Next page
Go to full version