Main > Main Forum
Rewiring control panel soon...Quick question about wire...
redbeard30:
I'm in the process of redoing my cp wiring and was going to buy some bulk 22awg wire, it is "tinned" copper strand. I don't recall any one mentioning not to use tinned wire. Will this be OK to use? The only Con's I saw was possibly lower conductivity(use for cp controls I can't imagine one would notice), and its a little stiffer than non tinned. Any advice?
PL1:
Should be fine if it is stranded instead of solid core.
Just to be sure, can you post a link?
Scott
CoryBee:
--- Quote from: PL1 on September 06, 2013, 09:43:55 pm ---Should be fine if it is stranded instead of solid core.
Just to be sure, can you post a link?
Scott
--- End quote ---
Sounds like it is going to be solid core if it is tinned
JDFan:
--- Quote from: CoryBee on September 06, 2013, 10:01:01 pm ---Sounds like it is going to be solid core if it is tinned
--- End quote ---
They do have tinned stranded wire also :
CoryBee:
Didn't say they didn't. Just less common in online and walk in retail shops.
OP don't leave us hanging!
Navigation
[0] Message Index
[#] Next page
Go to full version