Main > Main Forum

Building a Full-Size machine for $350 or less

<< < (3/5) > >>

yotsuya:

--- Quote from: Connorsdad on September 06, 2013, 04:33:13 pm ---I must be doing something wrong as I'm at £2.5k  :dizzy: and not finished yet  :cry:

Then again, fried 1 pololu board, scrapped 2 lots of carbon fibre vinyl and a few other mistakes here and there all add up lol

--- End quote ---

You're copying one of Griff's builds. If CoryBee is the Wal-Mart of BYOAC, Griff is the Tiffany's.

Connorsdad:
I'm hoping it turns out just like griffs :)

Sent from Amstrad CPC464

UFO:

Looks good, but like others, thats a big chunk of cash.

Im not sure what I could spend £2.5k on to build a cab... are you gold plating it buddy?

CoryBee:

--- Quote from: UFO on September 06, 2013, 07:48:58 pm ---Looks good, but like others, thats a big chunk of cash.
Im not sure what I could spend £2.5k on to build a cab... are you gold plating it buddy?

--- End quote ---

This ^^

Just curious too. Would be nice to see a breakdown of how you could spend over $2.5k on a cabinet. I know that isn't the most spent on a machine, I remember hearing about someone spending around $6k before.

roknrol:

--- Quote from: JDFan on September 06, 2013, 04:53:35 pm ---@roknrol -- just ask anyone in the lumber dept. and they'll point you toward it - they usually put any mis-cuts while cutting for customers or scraps the customer doesn't want after cutting or any warped\damaged boards there - Lowes has a similar bin with most pieces running from $0.25 to $2.00 so definitely worth looking through.   

--- End quote ---

Thanks for the tips. I'll definitely take a better look through next time I'm at the HD.  :cheers:

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version