Main > Main Forum
Ipac 4 Default Keycode Problems
xer0s:
--- Quote from: PL1 on September 05, 2013, 11:31:00 pm ---
--- Quote from: xer0s on September 05, 2013, 04:59:46 pm ---I understand that, but I have gone into Mame and mapped those two buttons to match the ipac default keycodes, and they still don't work...
--- End quote ---
So you used the WinIPac software to reprogram the IPac and changed the settings in MAME and it doesn't work?
When you open Notepad and press the P2 buttons and P3 joystick, does it type the desired keystrokes?
If the right keystrokes show up in Notepad, pull up the "Input (general)" menu -- verify the settings there are correct/change them as needed.
Next pull up the "Input (this Game)" menu in any game that you had previously changed settings -- verify the settings there are correct/change them as needed.
Scott
--- End quote ---
No, I hadn't changed the key codes on the ipac 4. I had only changed the Mame settings to match the ipac. When I tried to change the ipac key codes, I'm having another problem:
When I click "Program" in the bottom right, it says "Driver Installed OK", but then it says "Could not load program, try reinstall and or reboot with the board connected." I have tried all of this, and still no luck. I am running the program as Administrator. I'm also using a PS/2 to USB converter to connect to the PC. I have "USB" selected under options (and I've tried it with PS/2 selected).
Any ideas why I'm getting this error?
I have searches the forum, but found no solution. And I've also emailed Andy with no response...
yotsuya:
Connect a keyboard as well. I had a similar issue.
xer0s:
It's a laptop.
But I can try it anyways!
xer0s:
Alright, the only keyboard I have is PS/2, and the laptop doesn't have an input (which is why I'm using a converter for the ipac). Is there any way around this without buying another converter? Who knows if connecting a keyboard will even fix my problem?
severdhed:
Are you using the ultimarc usb cable? Or a 3rd party ps2 to usb adapter?
I don't think it will work using a 3rd party adapter.
Try connecting the ps2 keyboard into the pass through port on the ipac.
You may need to reprogram it on a different pc that you can connect it directly to.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version