Main > Main Forum

Securing PCI / Graphics in De-cased PC

<< < (4/6) > >>

charlieram:
You could just do what i did and get some of the brass standoffs and screw/glue them into your cab for the motherboard and a good old bit of meccano to secure the top of the Gfx card

Minwah:

--- Quote from: Nephasth on July 31, 2013, 02:49:14 pm ---I cut stainless screws/bolts all the time. Thread a nut on past the point you want to make your cut. Cut do desired length (I use a cutoff wheel, but a hack saw works too).

--- End quote ---

Ok thanks, I thought a saw (I only have a junior hacksaw) would have a hard time cutting stainless steel - I will give it a try.

TopJimmyCooks:
i've seen hot glue used as well- right at the corner of the board and the socket. 

UFO:
I love all these ideas, and the creative thought process that went into them!

Plenty to think about here - cheers guys...

 :cheers:

rockyrocket:

--- Quote from: TopJimmyCooks on August 01, 2013, 09:19:50 am ---i've seen hot glue used as well- right at the corner of the board and the socket.

--- End quote ---
+1 Hot glue works wonders.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version