Main > Main Forum

Did I screw it up already?

<< < (3/3)

BobA:
If you have enough room on the bit of pad a small drill bit in a dremel works well to add strain relief.

lilshawn:
i'd be cautious with a board that has tracks on both sides. Single sided would be fine to drill through. double sided, not so much.

BobA:
Lots of cheap game controllers are single sided to make them cheaply.  Contacts and chip in blob on same side.  Just flip over your board to check.

Navigation

[0] Message Index

[*] Previous page

Go to full version