Main > Main Forum
Rotating LCD Monitor - A Simple, Space Saving Technique?
lettuce:
Think something like this would be better.....
http://www.bracketsrus.co.uk/High-quality-adjustable-under-counter-/-cabinet-bracket-cs5-c190-p4609.html
As it only goes in and out and not on a hinge, now an ideal version would be one that rotates the display as well. You could then get a linear actuator and some programable grubbings to control the actuator to push the screen out and rotate by a push of a button!?. Here a vid that shows a wireless remote setup, but u get the idea.....
BadMouth:
VESA mounts are rarely if ever centered with the screen. An adapter plate aoul will need to be made to correct for that.
Sent using Board Express
darthpaul:
This seems very doable using an actuator to push it out and a motor/actuator/servo to turn it. Automating it shouldn't be much of a problem.
AGarv:
Good ideas for automating this using a pull-out that's non-VESA, hadn't considered those. LeChuck I will have to check out those cabs that use a pull-out approach already, thanks.
Another benefit for widescreen LCDs could be minimizing the vertical bezel height. You don't need the vertical 16:9 (or 16:10) aspect ratio, so just articulate the arm down several inches to hide part of the monitor below the control panel and expose something more like a 4:3 aspect ratio (rough picture below).
AGarv:
LeChuck, thanks for point out DMWorking247's alien bartop - very cool technique for a front-pull rotating monitor! Looks like he used a 4:3 set in a square bezel:
http://forum.arcadecontrols.com/index.php/topic,84251.0.html
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version